Oneiros EVA Fatigue Check

A reaction and arm-raise test, done rested (PRE) and again after the EVA (POST), to spot slowing that may come from fatigue.

Ready

Session

Mode

How to do the test

  1. Set up. Laptop at chest height. Stand 1.5–2 m back so your head, shoulders and both hands are in the picture. Use the same place and position for PRE and POST.
  2. Arm down, keep still. Let your right arm hang by your side.
  3. Wait for GO. It appears after a random wait. Don't move before it: that's a false start and the trial is repeated.
  4. On GO, raise your right wrist to shoulder height (the green line) as fast as you can. Then lower it again and wait for the next GO.

PRE: 3 minutes of trials. POST: 2 practice trials, then 10 counted ones (about 2 minutes). The camera image stays on this device.

Results

No session yet.

#Reaction (seconds)Movement (seconds)Total (seconds)Result
What do these numbers mean?
Reaction
Seconds from GO until your arm starts moving.
Movement
Seconds from starting to move until your wrist reaches shoulder height.
Total
Reaction + movement. This is the number that is compared.
Baseline
Your PRE result: the middle value (median) of your counted PRE trials, and how much they normally vary (the spread).
GREEN
POST is at most 1 spread slower than your baseline: within your normal variation.
YELLOW
1–2 spreads slower: some slowing, keep an eye on it.
RED
More than 2 spreads slower: clear slowing, possibly fatigue.
INSUFFICIENT DATA
Fewer than 5 valid trials: no colour is given. Repeat the session.
FALSE START
Moved before GO, or within 0.1 seconds of it (too fast to be a reaction). Repeated, not counted.
NO MOVEMENT
No response within 5 seconds of GO (a lapse). Counted as a lapse, not in the median.
TOO FAST
Arm movement faster than physically possible: a camera glitch. Repeated, not counted.
practice
The first 2 trials, to get used to the task. Never counted.

This is a screening and research tool, not a medical assessment. The colour rule (1 and 2 spreads) is a starting point that has not been validated.

Latest record

Latest record
-

PRE-EVA builds your own baseline

PRE-EVA checks are rested measurements that build a baseline of your own. It is off for you right now, so your results are compared with general reference values and get no normal / watch / alert label. Until then, run POST-EVA checks.

To use PRE-EVA, turn on Start my own baseline in your data panel. Once it has about 13 minutes of rested checks over 5 sessions, your POST-EVA checks are compared with your own baseline.

Open my data panel

How it works

The test measures how quickly you react to a GO signal and raise your right wrist to shoulder height. You do it once rested (PRE, e.g. before the EVA) and again afterwards (POST). If POST is clearly slower than your own usual variation, that can be a sign of fatigue.

Doing the test

  1. Stand 1.5–2 m from the laptop so your head, shoulders and both hands are in the picture. Use the same spot for PRE and POST.
  2. Enter your ID, choose PRE or POST, answer “How tired do you feel?”, press Start.
  3. Let your right arm hang still. After a random wait, GO! appears (with a beep).
  4. On GO, raise your right wrist to the green line at shoulder height as fast as you can, then lower it and wait for the next GO.

Why it works this way

Where the data goes

Only the measured times and your tiredness rating are saved, never video. The Saved results panel shows where.

A screening and research tool, not a medical assessment.