ONEIROS Blink & Yawn Test

Eye & mouth fatigue tracker: a 3-minute PRE-EVA, then a 30-second POST-EVA. Results are sent as ONEIROS cv.raw messages.

Backend: not set Ready

Setup

Source
Backend & advanced

How to do the test

  1. Sit about an arm's length from the camera, face well lit and fully in view. Look at the screen normally.
  2. Press Start PRE-EVA. The 3-minute PRE-EVA starts automatically when your face is found.
  3. Blink and behave naturally. Don't force blinks. Yawn if you need to.
  4. After the EVA, press Start POST-EVA (or P) for the 30-second POST-EVA window.

The camera image stays on this device. Only the measurements are saved and sent.

Results

No trial yet.

What do these numbers mean?
Blink rate
Blinks per minute of time the face was visible.
Eyes closed
Share of the time the eyes were closed (Eye Aspect Ratio below 0.25).
Median eye closure
Typical blink duration. Fatigue tends to make blinks slower and longer.
Long closures
Share of blinks lasting 400 milliseconds or more.
Yawns
Mouth wide open (Mouth Aspect Ratio above 0.22) for at least 15 frames.
Face visible
Share of the recording with a usable face image. Below 50% the data is not sufficient.
Issues
low coverage, face lost for a while (face missing more than 3 seconds), low frame rate (fewer than 15 frames per second), recording cut short (a blink/yawn still going 8 seconds after the window).

A demo / research tool, not a medical device. The thresholds come from the original Python tool.

PRE-EVA builds your own baseline

PRE-EVA checks are rested measurements that build a baseline of your own. It is off for you right now, so your results are compared with general reference values and get no normal / watch / alert label. Until then, run POST-EVA checks.

To use PRE-EVA, turn on Start my own baseline in your data panel. Once it has about 13 minutes of rested checks over 5 sessions, your POST-EVA checks are compared with your own baseline.

Open my data panel

How it works

The camera tracks your face (MediaPipe Face Landmarker, in the browser). From each frame it measures how open your eyes are (Eye Aspect Ratio) and your mouth (Mouth Aspect Ratio) and counts blinks, eye closure and yawns.

PRE-EVA 3 minutes, POST-EVA 30 seconds

What is saved / sent

Keys: P start POST-EVA · M face mesh on/off · Q/Esc quit. A demo tool, not a medical device.