ONEIROS Heart Rate Test

Heart rate from the camera, PRE-EVA and POST-EVA. PRE-EVA needs your own baseline turned on. Each session should last at least 2–3 minutes.

Backend: not set Ready

Setup

Source
Backend & advanced

How to do the test

  1. Face the camera in steady, even light (no flicker, no window behind you). Put your face inside the oval.
  2. Stay still and breathe normally until the countdown ends.
  3. After the EVA, press Start POST-EVA (or P) for the 30-second POST-EVA trial.
  4. PRE-EVA is only available once you turn on Start my own baseline in the portal (your "me" panel or your report). Until then the main button runs Start POST-EVA, and Start PRE-EVA is greyed out (press it to see how to unlock it). Your personal baseline needs at least 5 separate sessions of 2–3 minutes each; until it has formed, you are compared with general reference values.

The camera image stays on this device. Only the heart-rate readings are saved and sent.

Results

No trial yet.

What do these numbers mean?
Average / median
Heart rate over the trial, from one reading every 0.5 s.
Median absolute deviation
How much the readings vary.
Trend
Whether the heart rate rose (+) or fell (−) during the trial, in beats per minute, per minute.
Signal confidence
How clear the pulse was in the camera signal (0–1). Readings below 0.45 are rejected.
Issues
too few readings (fewer than 20), low coverage (less than half of the expected readings), large data gap (more than 5 seconds without a reading).

Camera heart rate needs stillness and steady light. A demo / research tool, not a medical device.

PRE-EVA builds your own baseline

PRE-EVA checks are rested measurements that build a baseline of your own. It is off for you right now, so your results are compared with general reference values and get no normal / watch / alert label. Until then, run POST-EVA checks.

To use PRE-EVA, turn on Start my own baseline in your data panel. Once it has about 13 minutes of rested checks over 5 sessions, your POST-EVA checks are compared with your own baseline.

Open my data panel

How it works

Each heartbeat changes the colour of your skin very slightly. The camera watches your forehead and cheeks (green outlines), and the POS algorithm turns those colour changes into a pulse wave and a heart rate. This runs entirely in the browser.

PRE-EVA 3 minutes, POST-EVA 30 seconds

What is saved / sent

Keys: P start POST-EVA · G face guide · F fullscreen · Q/Esc quit. A demo tool, not a medical device.